Voltage control relay EZ9C1240

Voltage control relay EZ9C1240
Request the price
Manufacturer: Schneider Electric
Model: 021.001.007
Weight: 310 g
In supplier's stock
Easy9 series voltage control relay EZ9C1240 by Schneider Electric is designed to protect different kinds of electric devices against overvoltage and undervoltage.
Relay can be used in single-phase circuit with voltage 230VAC and load no more than 40A. In case voltage surges up to 265V or drops down to 160V the relay switches off all the consumer devices. When voltage goes back to its normal operational mode relay automatically switches on the load in 25...35 seconds.
Specification
Main characteristics
SeriesEasy9
Relay typevoltage control relay
Control circuit voltage230VAC 50Hz
Rated current (Icw)40A
Pole configuration1P+N
Complementary characteristics
OvervoltageSwitching off upper threshold >265VAC
Reset upper threshold 253VAC
UndervoltageSwitching off low threshold 50...160VAC
Reset low threshold 195VAC
Resetautomatic after 25...35s
Main contacts configuration1NC (normally closed contact)
Rated insulation voltage (Ui)500VAC 50Hz
Rated operating voltage (Ue)440VAC 50Hz
Rated impulse withstand voltage (Up)4kV
Light indicationgreen: OK
quick red flash: overvoltage
slow red flash: undervoltage
Consumed power4VA
Fixationsnap-on mechanism
Mountingon DIN-rail
Overall dimensions (HхWхD)94 х 36 х 68 mm
Colorlight grey RAL7035
Electrical life12000 cycles
Mechanical life12000 cycles
Connectionstranded wire without cable end 1...10mm2
stranded wire with cable end 1...10mm2
solid wire 1...16mm2
Tightening torque2N·m
Environmental conditions
Degree of protectionIP40 conforming to IEC 60529 (installed in a panel board)
IP20 conforming to IEC 60529 (device itself)
Pollution degree2
Height above the sea2000m
Operating temperature-25°C...+55°C
Storage temperature-40°C...+80°C
Dimensions
Schneider Electric voltage control relay EZ9C1240 dimensions