Variable speed drive ATV212HD11N4 3 phase, 11kW, 380-480Vac

Variable speed drive ATV212HD11N4
Price: $446.45 ×
= 446.45
Manufacturer: Schneider Electric
Model: 027.021.036
Weight: 6.55 kg      Barcode: 3606480322518
In supplier's stock, Delivery time: 12/03/2018
Main
range of productAltivar 212
product or component typeVariable speed drive
device short nameATV212
product destinationAsynchronous motors
product specific applicationPumps and fans in HVAC
assembly styleWith heat sink
network number of phases3 phases
motor power kW11 kW
motor power hp15 hp
[Us] rated supply voltage380...480 V - 15...10 %
supply voltage limits323...528 V
supply frequency50...60 Hz - 5...5 %
network frequency47.5...63 Hz
EMC filterClass C2 EMC filter integrated
line current16.8 A 480 V
21.1 A 380 V
Complementary
apparent power17.1 kVA 380 V
prospective line Isc22 kA
continuous output current22.5 A 380 V
22.5 A 460 V
maximum transient current24.8 A 60 s
speed drive output frequency0.5...200 Hz
nominal switching frequency12 kHz
switching frequency12...16 kHz with derating factor
6...16 kHz adjustable
speed range1...10
speed accuracy+/- 10 % of nominal slip 0.2 Tn to Tn
torque accuracy+/- 15 %
transient overtorque120 % of nominal motor torque +/- 10 % 60 s
asynchronous motor control profileVoltage/frequency ratio, 2 points
Voltage/frequency ratio, automatic IR compensation (U/f + automatic Uo)
Voltage/frequency ratio, 5 points
Flux vector control without sensor, standard
Voltage/frequency ratio - Energy Saving, quadratic U/f
regulation loopAdjustable PI regulator
motor slip compensationAutomatic whatever the load
Adjustable
Not available in voltage/frequency ratio motor control
local signalling1 LED red DC bus energized
output voltage<= power supply voltage
isolationElectrical between power and control
type of cableIEC cable without mounting kit 1 45 °C copper 90 °C XLPE/EPR
IEC cable without mounting kit 1 45 °C copper 70 °C PVC
UL 508 cable with UL Type 1 kit 3 40 °C copper 75 °C PVC
electrical connectionTerminal 2.5 mm² AWG 14 VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES
Terminal 16 mm² AWG 6 L1/R, L2/S, L3/T
tightening torque2.5 N.m 22 lb.in L1/R, L2/S, L3/T
0.6 N.m VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES
supplyInternal supply for reference potentiometer (1 to 10 kOhm) 10.5 V DC +/- 5 % <= 10 A overload and short-circuit protection
Internal supply 24 V DC 21...27 V <= 200 A overload and short-circuit protection
analogue input number2
analogue input typeSwitch-configurable voltage VIA 0...10 V DC 24 V max 30000 Ohm 10 bits
Configurable voltage VIB 0...10 V DC 24 V max 30000 Ohm 10 bits
Configurable PTC probe VIB 0...6 probes 1500 Ohm
Switch-configurable current VIA 0...20 mA 250 Ohm 10 bits
sampling duration2 ms +/- 0.5 ms F discrete
2 ms +/- 0.5 ms R discrete
2 ms +/- 0.5 ms RES discrete
3.5 ms +/- 0.5 ms VIA analog
22 ms +/- 0.5 ms VIB analog
response time2 ms +/- 0.5 ms FM analog
7 ms +/- 0.5 ms FLA, FLC discrete
7 ms +/- 0.5 ms FLB, FLC discrete
7 ms +/- 0.5 ms RY, RC discrete
accuracy+/- 0.6 % VIA for a temperature variation 60 °C
+/- 0.6 % VIB for a temperature variation 60 °C
+/- 1 % FM for a temperature variation 60 °C
linearity error+/- 0.15 % of maximum value input VIA
+/- 0.15 % of maximum value input VIB
+/- 0.2 % output FM
analogue output number1
analogue output typeSwitch-configurable voltage FM 0...10 V DC 7620 Ohm 10 bits
Switch-configurable current FM 0...20 mA 970 Ohm 10 bits
discrete output number2
discrete output typeConfigurable relay logic FLA, FLC NO 100000 cycles
Configurable relay logic FLB, FLC NC 100000 cycles
Configurable relay logic RY, RC NO 100000 cycles
minimum switching current3 mA 24 V DC configurable relay logic
maximum switching current5 A 250 V AC resistive cos phi = 1 L/R = 0 ms FL, R
5 A 30 V DC resistive cos phi = 1 L/R = 0 ms FL, R
2 A 250 V AC inductive cos phi = 0.4 L/R = 7 ms FL, R
2 A 30 V DC inductive cos phi = 0.4 L/R = 7 ms FL, R
discrete input typeProgrammable F 24 V DC level 1 PLC 4700 Ohm
Programmable R 24 V DC level 1 PLC 4700 Ohm
Programmable RES 24 V DC level 1 PLC 4700 Ohm
discrete input logicPositive logic (source) F, R, RES <= 5 V >= 11 V
Negative logic (sink) F, R, RES >= 16 V <= 10 V
acceleration and deceleration rampsLinear adjustable separately from 0.01 to 3200 s
Automatic based on the load
braking to standstillBy DC injection
protection typeMotor phase break motor
Break on the control circuit drive
Thermal power stage drive
Overvoltages on the DC bus drive
Against exceeding limit speed drive
Against input phase loss drive
With PTC probes motor
Input phase breaks drive
Line supply overvoltage and undervoltage drive
Line supply undervoltage drive
Overcurrent between output phases and earth drive
Overheating protection drive
Short-circuit between motor phases drive
Thermal protection motor
dielectric strength3535 V DC between earth and power terminals
5092 V DC between control and power terminals
insulation resistance>= 1 MOhm 500 V DC for 1 minute
frequency resolution0.024/50 Hz analog input
0.1 Hz display unit
communication port protocolBACnet
METASYS N2
APOGEE FLN
Modbus
LonWorks
connector type1 open style
1 RJ45
physical interface2-wire RS 485
transmission frameRTU
transmission rate9600 bps or 19200 bps
data format8 bits, 1 stop, odd even or no configurable parity
type of polarizationNo impedance
number of addresses1...247
communication serviceRead device identification (43)
Write single register (06)
Read holding registers (03) 2 words maximum
Write multiple registers (16) 2 words maximum
Monitoring inhibitable
Time out setting from 0.1 to 100 s
option cardCommunication card LonWorks
operating positionVertical +/- 10 degree
width180 mm
height232 mm
depth170 mm
product weight6.45 kg
power dissipation in W430 W
air flow147 m3/h
functionalityMid
specific applicationHVAC
IP degree of protectionIP21
Variable speed drive application selectionBuilding - HVAC : compressor for scroll
Building - HVAC : fan
Building - HVAC : pump
Motor power range AC-37...11 kW at 380...440 V 3 phases
7...11 kW at 480...500 V 3 phases
motor starter typeVariable speed drive
Environment
electromagnetic compatibilityConducted radio-frequency immunity test level 3 IEC 61000-4-6
Voltage dips and interruptions immunity test IEC 61000-4-11
1.2/50 µs - 8/20 µs surge immunity test level 3 IEC 61000-4-5
Electrical fast transient/burst immunity test level 4 IEC 61000-4-4
Electrostatic discharge immunity test level 3 IEC 61000-4-2
Radiated radio-frequency electromagnetic field immunity test level 3 IEC 61000-4-3
pollution degree2 IEC 61800-5-1
IP degree of protectionIP20 on upper part without blanking plate on cover EN/IEC 61800-5-1
IP20 on upper part without blanking plate on cover EN/IEC 60529
IP21 EN/IEC 61800-5-1
IP21 EN/IEC 60529
IP41 on upper part EN/IEC 61800-5-1
IP41 on upper part EN/IEC 60529
vibration resistance1 gn 13...200 Hz EN/IEC 60068-2-8
1.5 mm 3...13 Hz EN/IEC 60068-2-6
shock resistance15 gn 11 ms IEC 60068-2-27
environmental characteristicClasses 3C1 IEC 60721-3-3
Classes 3S2 IEC 60721-3-3
noise level51 dB 86/188/EEC
operating altitude1000...3000 m limited to 2000 m for the Corner Grounded distribution network with current derating 1 % per 100 m
<= 1000 m without derating
relative humidity5...95 % without condensation IEC 60068-2-3
5...95 % without dripping water IEC 60068-2-3
ambient air temperature for operation-10...40 °C without derating
> 40...50 °C with derating factor
ambient air temperature for storage-25...70 °C
standardsEN 61800-3 environments 1 category C3
EN 55011 class A group 1
IEC 61800-3 category C2
IEC 61800-3 environments 2 category C2
IEC 61800-3 environments 1 category C2
IEC 61800-3 category C3
EN 61800-3 environments 1 category C2
IEC 61800-3 environments 1 category C3
EN 61800-3 category C3
EN 61800-5-1
EN 61800-3 environments 1 category C1
IEC 61800-3 environments 1 category C1
IEC 61800-3 environments 2 category C1
EN 61800-3
IEC 61800-5-1
EN 61800-3 environments 2 category C3
EN 61800-3 category C2
EN 61800-3 environments 2 category C1
EN 61800-3 environments 2 category C2
UL Type 1
IEC 61800-3
IEC 61800-3 environments 2 category C3
product certificationsCSA
UL
NOM 117
C-Tick
markingCE